woogaq.blogg.se - Boneka super jumbo 2 meter

Installing ZADIG - no STM32 BOOTLOADER option, or any other relevant option in the list.

Installing the latest STM USB VCP Drivers, rebooting - nothing changed.

Installing the latest CP210x Drivers, rebooting - nothing changed.

so yeah, that would be too easy, wouldn't it. Tried it, but it gets stuck on "Searching for Flight Controllers.". Then I found about Impulse RC Driver Fixer software, which should basically find any connected FCs, download their drivers and install them automatically.

Which is, apparently, a generic and non-descriptive error, coming from a damaged or corrupt driver and designed to ruin my mood for weeks. STMicroelectronics Virtual COM Port Version 1.4.0.0.Īnd, it results in a "This device cannot start" Code 10 error. However, since it didn't change anything either, I then deleted the pair in VSPD again and uninstalled that software.Īnother thing which I tried was going into Device Manager - highlighting Ports (COM and LPT) section - Action - Add Legacy Hardware - manual selection - Ports (COM and LPT) - STMicroelectronics. They did appear in Device Manager next to the COM1 port. There, I created a pair of virtual COM ports (COM2, COM3). Well, as you can see in the image above, I don't have USB Serial Converter.Īfter searching for a solution, I tried installing VSPD software - Virtual Serial Port Drive by Eltima. I noticed some people having similar issues were recommended to open Device Manager, find USB Serial Converter, go into Properties and -somewhere- tick the VCP option, to make virtual COM ports appear. So, again, I install them, the message about successful installation appears, and boom. So, I tried to google STM32 bootloader drivers, and after some digging, I downloaded basically the same VCP driver I was installing earlier. This is how my Device manager looks like, FC connected. When connected while holding a button on the FC (which I presume forces it to connect in bootloader mode), the red LED stays lit, and another small red LED turns on.When connected as it is, one red LED stays lit all the time, while a blue one keeps flashing.

I don't even hear the "USB device connected" sound in Windows, and nothing happens in the Device Manager after connecting it. There's an issue with connecting it to my computer, it seems the system doesn't recognize it at all after plugging the FC in a USB port. My computer is running Windows 10 64-bit, updated to build 17763.529.

I'm building a mini FPV drone based on the MATEKSYS F405-CTR flight controller - link.Īfter some reading, I decided to flash BetaFlight firmware on the FC. After several days of unsuccessful attempts I decided to reach out to this forum, asking for help.